How to change the glass on an analog watch

Introduction

When the glass on an analog watch breaks, it can be a frustrating and stressful experience. However, replacing a watch glass can be easier than you might think, as long as you follow the correct steps and have the right tools. In this glossary, we’ll walk you through the process of replacing an analog watch glass, providing detailed instructions and helpful tips to ensure a successful outcome.

Step 1: Gather the necessary tools

Before you begin the process of replacing your watch glass, it’s important to make sure you have all the necessary tools. You’ll need a set of screwdrivers, tweezers, a heat gun, a soft cloth, and of course, the new replacement glass for your watch.

Step 2: Remove the watch band and back cover

The first step is to remove the watch band, if present, and the back cover. Use the screwdrivers to loosen the screws holding the back cover in place, then use the tweezers to carefully pry it off. Place the back cover and screws in a safe place so you don't lose them.

Step 3: Heat the watch glass

Using a heat gun, gently heat the watch glass to soften the glue holding it to the case. Be careful not to overheat the glass, as this can damage other parts of the watch. Once the glue has softened, use the tweezers to carefully remove the old glass.

Step 4: Clean the glass area

With the old glass removed, carefully clean the area where the new glass will be placed. Use the soft cloth to remove any glue residue or dirt, ensuring the surface is clean and smooth for the installation of the new glass.

Step 5: Install the new glass

With the area clean and prepared, it’s time to install the new glass into the watch. Carefully position the glass in the correct location and press gently to secure it to the case. Make sure the glass is level and fits snugly for a perfect finish.

Step 6: Replace the back cover and band

With the new glass successfully installed, replace the back cover of the watch and tighten the screws with the screwdrivers. Then, replace the watch band, if applicable, ensuring that it is securely fastened and comfortable on your wrist.

Step 7: Test the watch

Before using your watch normally, it is important to test that the new crystal is properly installed and secure. Check that the crystal is firmly attached to the case and that there are no visible gaps or cracks. Adjust the time and date if necessary, and your watch is ready to use again.

Final considerations

Replacing the glass on an analog watch may seem like a daunting task, but with the right tools and following the correct steps, you can successfully complete the task. Remember to be patient, work carefully, and follow the detailed instructions provided in this glossary. With a little practice, you’ll be able to replace your watch glass like a true pro.